pin holder tool

230066

New

1 piece pin holder tool with 5mm mandrel. You can use this tool for invisible rings but you can melt the glass direct on the surgical steel pin. You can hold the pin in the flame with this tool. Please screw strong the pin into the tool with pliers. The steel pins get a dark patin in the flame.

To make an invisible rings you will need short beadpins and screws. Please watch my invisible Ring tutorial video.

 If you melt a glass on total length of the rods, please let free the end of pins or cover the end (3-4mm) of the pin with "bead release". You can melt the glass just on the last 3-4mm of the pins without bead release too.  To remove this patin polish the pin (if the pin is visible). Please heat the pin gently. Pin is very slim, if you heat it to long, you can melt it.

The holder tool is 20 cm long.

WITHOUT BEAD PIN! 

This is a tool for flamework, not a part to build jewelry of.

Tutorial video
"Anleitung"
 PDF Tutorial
"Anleitung"

More details

8,00 €

Add to wishlist

STEEL INTERCHANGEABLE JEWELRY

Lampwork glass bead pin holder tool
Beach Buggy is a interchangeable jewelry, screw-on system for lampwork bead jewelry. All metal elements are made from surgical steel (stainless steel), a material of many virtues. Surgical steel is one of the hardest kinds of steel, it does not get worn, does not get colorized and does not induce allergic reactions. It makes the elements long-lasting, they can be assembled and disassembled multiple times. The steel is so hard that you can even use pliers to gently hold and turn the elements without scratching them. You can hold the steel lampwork bead pins into the flame of a lampwork touch and melt glass onto it. All elements are threaded they can be connected by screwing. The lampwork bead pin and the various connector elements provide virtually unlimited possibilities to create fantastic jewelry. The diameter of the lampwork bead pins are 1.1 mm and the various silicon tubes and converters provide a tight fit for beads with holes of a diameter of 2-3 mm. The system is not recommended for holes with a diameter larger than 3 mm as the size of the end elements (4-5 mm) are too small for such beads. The recommended bore diameter is 1.5-2.5 mm.