2x bead pins 12mm - 28mm

New

Two pieces surgical steel - stainless steel bead pin for Beach Buggy system. The size given for the bead pin is always the net length – there is an additional 1.5 mm long thread on both sides so the total length is the given length plus 3 mm. 

You can melt the glass directly on the rod so no end-piece is necessary. If you melt a glass on total length of the rods, please let free the end of pins or cover the end (3-4mm) of the pin with "bead release". You can melt the glass just on the last 3-4mm of the pins without bead release too.  Use aways a controlled kiln cold down for glass. Use my pin holder tool for flamework.

You will receive 2 pieces bead pins with the same size (between 8mm and 28mm).

pin Ø 1.1mm. 

PLEASE SELECT THE LENGTH OF BEAD PIN!

From 10 pieces of one size, we offer 10% discount.
From 20 pieces of one size, we offer 20% discount.

Tutorial video
"Anleitung"
PDF tutorial
"Anleitung"

More details

3,00 €

Add to wishlist

Volume discounts

Quantity Discount You Save
10 10% Up to 3,00 €

STEEL INTERCHANGEABLE JEWELRY

Beach Buggy is a interchangeable, screw-on system for lampwork bead jewelry. All metal elements are made from surgical steel (stainless steel), a material of many virtues. Surgical steel is one of the hardest kinds of steel, it does not get worn, does not get colorized and does not induce allergic reactions. It makes the elements long-lasting, they can be assembled and disassembled multiple times. The steel is so hard that you can even use pliers to gently hold and turn the elements without scratching them. You can hold the steel lampwork bead pins into the flame of a lampwork touch and melt glass onto it. All elements are threaded they can be connected by screwing. The lampwork bead pin and the various connector elements provide virtually unlimited possibilities to create fantastic jewelry. The diameter of the lampwork bead pins are 1.1 mm and the various silicon tubes and converters provide a tight fit for beads with holes of a diameter of 2-3 mm. The system is not recommended for holes with a diameter larger than 3 mm as the size of the end elements (4-5 mm) are too small for such beads. The recommended bore diameter is 1.5-2.5 mm.