Two pieces surgical steel bead pin for Beach Buggy system. The size given for the rod is always the net length – there is an additional 1.5 mm long thread on both sides so the total length is the given length plus 3 mm.
thread size: M1.1
You can melt the glass directly on the rod so no end-piece is necessary. If you melt a glass on total length of the rods, please let free the end of pins or cover the end (3-4mm) of the pin with "bead release". You can melt the glass just on the last 3-4mm of the pins without bead release too. Always use a controlled kiln to cold down the glass. Use my pin holder tool for flamework.
You will receive 2 pieces bead pins with the same size 65mm or 70mm). Diameter is 1.1mm.
PLEASE SELECT THE LENGTH OF BEAD PIN!