No products
Judit necklace - adjustable for any beadsizes
New product
Judit necklace - the place of the beads is adjustable
The necklace has two stainless steel beads. One is a join-bead that joins the chain and one end-bead that holds your glass bead.You can slide the join-bead up and down the chain to adjust the spacing for the glass bead.
The end-bead is a bayonet clasp.
Gently press the bead and turn to the right to release the clasp.
Install your glass bead. Close the end-bead. Find the position where you can gently push the end-bead into the end piece of chain and turn it to the left, the clasp is closed.
You can wear glass beads from 2 mm bead hole with the chain.
Always install your glass beads over a table.
On the photo you can see a beautiful pearl from Sabine Frank! 1.6 mm snake chain, the stainless steel beads are 6 mm in diameter. Length: 80 cm, 85 cm, 90 cm.
Choose a length!
WITHOUT GLASS BEAD!
More info
Beach Buggy is a interchangeable jewelry, screw-on system for lampwork bead jewelry. All metal elements are made from surgical steel (stainless steel), a material of many virtues. Surgical steel is one of the hardest kinds of steel, it does not get worn, does not get colorized and does not induce allergic reactions. It makes the elements long-lasting, they can be assembled and disassembled multiple times. The steel is so hard that you can even use pliers to gently hold and turn the elements without scratching them. You can hold the steel lampwork bead pins into the flame of a lampwork touch and melt glass onto it. All elements are threaded they can be connected by screwing. The lampwork bead pin and the various connector elements provide virtually unlimited possibilities to create fantastic jewelry. The diameter of the lampwork bead pins are 1.1 mm and the various silicon tubes and converters provide a tight fit for beads with holes of a diameter of 2-3 mm. The system is not recommended for holes with a diameter larger than 3 mm as the size of the end elements (4-5 mm) are too small for such beads. The recommended bore diameter is 1.5-2.5 mm.